10. Bear Coaster

Bring a touch of the forest to your coffee table with this charming, friendly bear coaster. Featuring neat little rounded ears, sweet safety eyes, and a stitched muzzle patch, this quick and beginner-friendly design works up in under an hour to protect your surfaces in adorable style.
Quick Facts
| Skill level | Finished size | Yarn | Hook | Time |
|---|---|---|---|---|
| Beginner | 4 in / 10 cm diameter | DK cotton (Cat. 3) | 3.5 mm (US E/4) | 35 minutes |
Materials You Will Need
- DK weight 100% cotton yarn: light brown (approx. 15 grams / 35 metres), dark brown (approx. 3 grams / 7 metres), cream (approx. 3 grams / 7 metres)
- 3.5 mm (US E/4) crochet hook
- Two 6 mm black safety eyes with backings
- Small amount of black embroidery floss or leftover dark brown yarn for facial details
- Yarn needle for weaving in ends
- Scissors
- Stitch marker
Gauge
The first 3 rounds of the Main Body measure approximately 4 cm across. Exact gauge is not critical for this project, but work with a consistent, firm tension to ensure the coaster lies flat and provides a sturdy surface for mugs.
Abbreviations (US Terms)
- ch – chain
- sc – single crochet
- hdc – half double crochet
- dc – double crochet
- inc – single crochet increase (work 2 sc in the same stitch)
- sl st – slip stitch
- st(s) – stitch(es)
- Rnd – round
- FO – fasten off
UK terms: sc = dc, hdc = htr, dc = tr.
Pattern Notes
- The Main Body and Muzzle are worked in continuous spirals without joining rounds unless specified. Use a stitch marker to track the first stitch of each round.
- The stitch count at the end of each round is shown in brackets like (12).
- Ears and Muzzle are made separately and then sewn onto the Main Body.
Instructions
Main Body – Light Brown, make 1
Rnd 1: 6 sc in a magic ring (6)
Rnd 2: inc x 6 (12)
Rnd 3: (1 sc, inc) x 6 (18)
Rnd 4: (2 sc, inc) x 6 (24)
Rnd 5: (3 sc, inc) x 6 (30)
Rnd 6: (4 sc, inc) x 6 (36)
Rnd 7: (5 sc, inc) x 6 (42)
Rnd 8: (6 sc, inc) x 6 (48)
Rnd 9: (7 sc, inc) x 6 (54)
Rnd 10: (8 sc, inc) x 6 (60)
Sl st in next st to finish the round. FO, leave a 30 cm tail for securing ends.
Ears – Light Brown, make 2
Rnd 1: 6 sc in a magic ring (6)
Rnd 2: inc x 6 (12)
Rnd 3: (1 sc, inc) x 6 (18)
Sl st in next st. FO, leave a 20 cm tail for sewing.
Muzzle – Cream, make 1
Rnd 1: 6 sc in a magic ring (6)
Rnd 2: inc x 6 (12)
Rnd 3: (1 sc, inc) x 6 (18)
Sl st in next st. FO, leave a 25 cm tail for sewing.
Assembly
Position the cream muzzle centered over Rnds 3 to 7 of the Main Body. Pin in place and sew around the edge, leaving a small opening to add a tiny pinch of stuffing if desired, then close completely. Attach the two ears at the top of the Main Body, spanning across Rnds 9 and 10, spaced about 6 stitches apart. Insert the safety eyes between Rnds 5 and 6 of the Main Body, just above the top edge of the cream muzzle, with about 4 stitches between them, and secure the backs.
Finishing
Using black embroidery floss, stitch a small inverted triangle nose in the upper center of the cream muzzle. Add a vertical line straight down from the nose, followed by a sweet smiling curve on either side. Weave in all remaining loose ends securely on the wrong side of the work.
Tip: Block your finished coaster with a warm iron and a damp cloth if the edges curl slightly, giving it a crisp and professional finish.
Tips and Common Mistakes
- Always use a stitch marker at the start of continuous rounds so you do not lose your place in the circle math.
- Do not stuff the ears or muzzle too heavily; they should remain relatively flat against the coaster.
- Ensure cotton yarn is used rather than acrylic, as cotton absorbs moisture better and resists heat from warm mugs.
- Count your stitches at the end of every round to prevent accidental increases or decreases that cause the coaster to warp or cup.
Frequently Asked Questions
Can I use acrylic yarn instead of cotton?
Cotton is recommended because it is more absorbent and withstands heat from hot mugs better than acrylic, but acrylic can be used if that is what you have available.
Can I make this safe for a baby under three?
Yes, to make this toy or coaster safe for a young child, embroider the eyes using black yarn or embroidery floss instead of using plastic safety eyes, which pose a choking hazard.
How do I wash my crochet coaster?
Hand wash gently in cool water with mild soap, reshape while damp, and lay flat to dry completely.
Can I adjust the size of the coaster?
You can make a larger coaster by continuing the flat circle increases for more rounds, or a smaller one by stopping the increases earlier.
📄 Your free PDF pattern











